Heavy-Duty Bilge Pump 2000 SeriesPart #: 4760-4Heavy-Duty Blige Pumps integrate the highest quality bearings, brushes, alloys and magnets designed to withstand extreme usage cycles. Pump all employs an exclusive shaft and motor compartment, reducing wear and significantly extending pump life. Advanced resin compositions incorporated in exterior to resist chemicals such as engine oil, aggressive detergents and hose plasticizers. Attwood's Heavy Duty bilge has unsurpassed durability and efficiency in a compact design to ensure electrical energy is converted to the pump rather than excess heat.Attwood's highest capacity pump! Ball-bearing design provides for cooler motor operation and longer life, Delivers over 2000 GPH at open flow while drawing less than 7-amps.Features:
Attwood Heavy Duty Bilge Pumps are the newest development in high output pumps. All models have a removable strainer basket for simple installation and easy cleaning. There are two ways to configure your Heavy Duty Bilge Pump - Automatic Operation or Manual Operation. The bilge pump system can be converted to fully-automatic operation by installing the S3 Electronic Bilge Switch (part no. 4801 or 4802).
All boats over 20' (6.1 m) in length which have sleeping accommodations (excluding fold-out cockpit seats) require automatic bilge pump systems. For fully-automatic operation, follow the automatic electronic switch installation and automatic operation wiring instructions.
Completely cover the mounting pad with fiberglass. Saturate the fiberglass with resin, and press the fiberglass edges down against the hull to adhere the pad in place. Roll out the fiberglass to remove any uneven surfaces, air bubbles, or excess resin.
To Install mounting pad on aluminum hull : If your boat is not equipped with a bilge pump mounting pad we recommend that you consult your boat dealer or repair facility for instructions regarding fabrication and installation of a suitable mounting pad.
Pump Mounting Instructions