1. Home
  2. DC Power
  3. Alternators and Regulators
  4. Pulley Kits
  5. Serpentine belt kits for Yanmar engines
  6. Balmar 48-YSP-4JH-E Pulley Kit for Yanmar 4JH2-E -TE -HTE -DTE -UTE
Balmar 48-YSP-4JH-E Pulley Kit for Yanmar 4JH2-E -TE -HTE -DTE -UTE
Balmar Serpentine Pulley Kit

Balmar 48-YSP-4JH-E Pulley Kit for Yanmar 4JH2-E -TE -HTE -DTE -UTE

On sale $495.00 $443.00
Balmar Altmount Serpentine pulley kit permits mounting a much larger alternator in lieu of the standard model because of its 10 groove serpentine belt - for select Yanmar engines. This kit, model 48-YSP-4JH-E is for a Yanmar 4JH2 -TE -THE -GTE -UTE, 4JH, 4JHE -TE -THE -DTE, 3JH2-E
p/n: 48-YSP-4JH-E
Availability: In stock

These Altmount Kits by Balmar offer the opportunity to install a larger alternator than would otherwise be possible. They are designed to fit select engine models, the list expands every day so if you don't see your engine listed do give us a call. Alternator upgrades using a single drive belt are limited by the amount of power that can be transferred by the belt but using a serpentine belt considerably increases the possibilities. The kits include a set of serpentine pulleys to go over the crankshaft and water pump pulley and replace the alternator pulleys and come with a matching serpentine belt and a spare. They are sold for specific engine models only. The alternators need to be purchased separately. If you order an alternator with a kit it will come with the appropriate pulley pre-installed. Installation is relatively easy. The kit comes with two belts but purchasing an additional spare belt is recommended as these are not typical serpentine belts.

Yanmar kits are available for Yanmar 6L, 4JH, 3JH, 3GM, 3HM, 3YM, and 2 YM engines.  The photos shown above are representative, I dont have photos of every kit or every installation

Read my BLOG POST about installing one of these kits.


Installation notes are on the blog post

My blog post has installation notes for a serpentine kit on a Yanmar



Notice

This kit is designed for use with a Balmar alternator. If you want to use it with your stock Hitachi alternator then you also need to purchase the Hitachi Pulley 48-AM-97. This special Hitachi pulley fixes an alignment issue. It may be possible to use the kit with any alternator that has a 17mm shaft diameter, but the fit and alignment is not guaranteed.   





Related Items

Second Alternator Kit for Yanmar Engines
$1,149.60 $1,028.00 Sale
Can ship direct from Balmar if you select a paid shipping method.
Spare Serpentine Belt
$43.99 $39.99 Sale
Some sizes in stock

Recently Viewed Items

TOP