1. Home
  2. DC Power
  3. Alternators and Regulators
  4. Pulley Kits
  5. Serpentine belt kits for Yanmar engines
  6. Balmar 48-YSP-4LH-A Pulley Kit for Yanmar 4LH-A
Balmar 48-YSP-4LH-A Pulley Kit for Yanmar 4LH-A
Balmar Serpentine Pulley Kit

Balmar 48-YSP-4LH-A Pulley Kit for Yanmar 4LH-A

On sale $643.50 $566.99
p/n: 48-YSP-4LH-A
Availability: Available to order

These Altmount Kits by Balmar offer the opportunity to install a larger alternator than would otherwise be possible. They are designed to fit select engine models, the list expands every day so if you don't see your engine listed do give us a call. Alternator upgrades using a single drive belt are limited by the amount of power that can be transferred by the belt but using a serpentine belt considerably increases the possibilities. The kits include a set of serpentine pulleys to go over the crankshaft and water pump pulley and replace the alternator pulleys and come with a matching serpentine belt and a spare. They are sold for specific engine models only. The alternators need to be purchased separately. If you order an alternator with a kit it will come with the appropriate pulley pre-installed. Installation is relatively easy. Each kit comes with two belts. We don't recommend you order additional belts until you check the fit. Installations vary and sometimes we have to swap out belts. We will swap unused belts for free we just ask you to pay shipping.

Yanmar kits are available for Yanmar 6L, 4JH, 3JH, 3GM, 3HM, 3YM, and 2 YM engines.  The photos shown above are representative, I dont have photos of every kit or every installation

Read my BLOG POST about installing one of these kits.

Yanmar pulley kits

Installation notes are on the blog post

My blog post has installation notes for a serpentine kit on a Yanmar



Notice

This kit is designed for use with a Balmar 6 series or XT series alternator. If you want to use it with your stock Hitachi alternator then you also need to purchase the Hitachi Pulley 48-AM-97. This special Hitachi pulley fixes an alignment issue. It may be possible to use the kit with any alternator that has a 17mm shaft diameter, but the fit and alignment is not guaranteed.   





Related Items

Spare Serpentine Belt
$46.95
Some sizes in stock


Recently Viewed Items

TOP