Busbars and Terminal Strips
Tinned Copper Busbars
> Blue Sea 2722 DualBus Plus Bus Bar with Cover 1/4" stud
Blue Sea Systems 2722 DualBus Plus 1/4" stud
Blue Sea 2722 DualBus Plus Bus Bar with Cover 1/4" stud
Questions about this item? Ask here.
See 1 Questions
16 in stock
Add to Cart
Get a Quote
Add to Wish List
Questions and Answers
Combines negative and positive buses on one block
Clear polycarbonate cover snaps on to meet Coast Guard and ABYC insulation requirements
Reinforced polycarbonate base
AC Rating 300 Volts 130 Amps
DC Rating 48 Volts 150 Amps
Each positive or negative bus contains 5 x 10-32 screw terminals and two 1/4" stud terminals
See drawing for dimensions
would this item help me with the mess of a tangle of wires connected to my batteries? Can I connect negative and positive wires to the same bar? thanks
Yes you can connect positive to one bus and negative to the other, that is what it is intended for. Yes you can use it to reduce a clutter of wires, provided that the total load does not exceed 150 Amps.
If you are using this in your battery area you should also have circuit protection on these wires and depending on the amperage of the loads you might be better off getting a fuse block
Was this answer helpful?
3 of 3
Customer(s) found this Answer helpful.
Answer provided by:
Peter Kennedy (4/11/2016)
(Submit an answer)
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to
Any Blue Sea Systems product with which a customer is not satisfied may be returned to the manufacturer for a refund or replacement at any time.
Pacer Marine Ring Terminals 16-14 awg #10 Ring (10 pack)
In stock with Free Shipping for orders over $45
Pacer Marine Heat Shrink Ring Terminals 12-10 awg #10 Ring (5 pack)
Ancor 230224 Nylon Ring Terminal 12-10 awg with 1/4" hole - 4 pack
Recently Viewed Items