AC Source Selector Switches
> Blue Sea 9093 AC Selector Switch, 120+120/240V 63A OFF+2
Blue Sea Systems #9093 AC Selector Switch, AC 120+120/240VAC 63A OFF+2
Blue Sea 9093 AC Selector Switch, 120+120/240V 63A OFF+2
Questions about this item? Be the first to ask here.
Put me on the Waiting List
Add to Wish List
This AC Selector Switch would be if you wanted to plug into two 120 volt 30 Amp supplies on the dock but had a generator that provided 120/240 volts at 50 Amps.
Switch outputs to two 120V AC load groups
See Schematic for full details
Compact solution when circuit protection is provided elsewhere
Mounts in panels up to 0.16" (4.00mm) thick
Heavy duty industrial rated AC Selector Switch
Intuitive function - One hand operation
600 Volt AC max 63 Amps
Made for Blue Sea Systems by Kraus and Naimer
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to
The switch is not a circuit breaker. ABYC Standards require that a double pole circuit breaker be installed within 10 feet of the shore power inlet, ahead of this switch. The measurement is made along the conductors.
This switch is for two 120 Volt AC sources and one 120/240 Volt source and switches the hot and neutral lines. The ground wire is never switched.
The switch itself is designed to be mounted in a thin sheet. The maximum thickness of the sheet that can be used is 4mm (0.16") because the center pin for the knob is not long enough to allow the switch to be mounted in anything thicker. You can however purchase this same switch pre-mounted in a panel which makes it much easier to install. The
is a conventional flat panel and the
is one of the 360-Series panels. Both feature indicator lights for "power available" and "reverse polarity" and come with a set of stick on labels.
Manufacturers web page for this product
Marinco SeaLink Dual USB Charger Receptacle
DEI Marine Fail Safe Plus 50/60 Amp Galvanic Isolator
Recently Viewed Items