VictronConnect settings lock - a tool for installers

Posted by Peter Kennedy on 3/20/2024 to Training

Installers will welcome this new Settings Lock feature in the VictronConnect App where it is now possible to lock the settings with VictronConnect password.

(0) Comments

New ECO friendly settings to prioritize solar and wind for battery charging

Posted by Peter Kennedy on 9/25/2023 to System Integration

Victron's new solar and wind priority feature allows a shore power connected system to prioritize alternative energy when charging batteries. This much requested feature is finally available and ready to use.

(0) Comments

Latest updates to Victron VRM

Posted by Peter Kennedy on 5/15/2023 to System Integration

The Victron VRM Portal is a free service that allows you to connect your Victron System to the internet and view and control it remotely from anywhere in the world. The features are constantly being updated and this post, which will be edited whenever a major change is made, will keep you up to date on what is happening,

(0) Comments

Programming your MultiPlus or Quattro with VictronConnect

Posted by Peter Kennedy on 5/8/2023 to System Integration

This article was updated in July 2022 and covers programming your MultiPlus or Quattro with VictronConnect. The program has continued to evolve and is now at the point where it can be used for all programming unless you need to use the "Assistants". For that you still need the VE Config program

(4) Comments

Setting up your Cerbo GX device to work on the Victron VRM

Posted by Peter Kennedy on 1/24/2023 to System Integration

We recommend you set up your Victron Cerbo GX on the Victron VRM portal as part of the installation procedure. It only takes a few minutes to set up a VRM account and is easier to do while the instructions are at hand and the installation is all fresh in your mind. Then if you ever need remote support it will be all set up and you will be able to put your Cerbo GX online and share your site.

(3) Comments

Latest Updates to VictronConnect app

Posted by Peter Kennedy on 9/14/2022 to System Integration

https://www.victronenergy.com/panel-systems-remote-monitoring/victronconnect

Victron Connect is the app used to configure, monitor, update and diagnose your Victron product. The program is constantly evolving and this article is intended to keep you up to date on the latest improvements. It will be updated whenever a major update is made.

(0) Comments

Firmware updates with Victron Connect

Posted by Peter Kennedy with Victron Energy on 4/18/2019 to System Integration

Firmware updates to equipment connected using Victron Connect can be made offline as long as your Victron Connect App is up to date. This blog is a reposting of the original Victron Blog Post on the subject.

(0) Comments

Victron Bluetooth pairing code

Posted by Peter Kennedy on 3/14/2019 to System Integration

This article tells you what to do if you are asked for a Bluetooth pairing code for your Victron Bluetooth device

(0) Comments

Customizing your Venus

Posted by Peter Kennedy on 5/23/2018 to Software

We know that Victron software is open source and we know that really clever people can write their own programming integrations, and we know that the Victron Venus is the most tweakable and programmable item in the Victron product range. However talking about this and actually doing it are not the same and for most of us this is too intimidating an excercise to attempt. Here is the story of one installation with all the explanations necessary to accomplish it yourself.....

(1) Comments