1. Home
  2. DC Power
  3. Battery Chargers
  4. Victron Skylla Battery Chargers
  5. Skylla IP44 Chargers
  6. Victron Energy SKY024030000 Skylla-IP44 Battery Charger 24/30(1+1) 120-240V
Victron Energy SKY024030000 Skylla-IP44  Battery Charger 24/30(1+1) 120-240V
Victron Energy Skylla-IP44 24/30(1+1) 120-240V

Victron Energy SKY024030000 Skylla-IP44 Battery Charger 24/30(1+1) 120-240V

On sale $912.00 $775.20
24 Volt 30 Amp Battery Charger with two isolated outputs
p/n: SKY024030000
Availability: Normally available in one week or less
Share |
The Skylla IP44 is Victron's most sophisticated and most programmable battery charger. Unless you go to one of the MultiPlus or Quattro inverter chargers this Skylla IP44 gives you the most control available over the entire charge cycle. This charger is suitable for remote control when used with an external BMS and Lithium Batteries.

Skylla-IP44 (1+1): two outputs to charge 2 battery banks
The Skylla-IP44 (1+1) features 2 isolated outputs. The second output, limited to approximately 3A and with
a slightly lower output voltage, is intended to top up a starter battery.

IP44 protection
Steel epoxy powder coated case and splash proof. Withstands the rigors of an adverse environment: heat,
humidity and salt air.
Circuit boards are protected with an acrylic coating for maximum corrosion resistance.
Temperature sensors ensure that power components will always operate within specified limits, if needed
by automatic reduction of output current under extreme environmental conditions.

LCD display
For status monitoring and to easily adapt the charge algorithm to a particular battery and its conditions of
use.
CAN bus interface (NMEA2000)
To connect to a CAN bus network, to a Skylla-i Control panel or to the Color Control digital display.

The Skylla-IP44 (1+1) features 2 isolated outputs. The second output, limited to approximately 3A and with a slightly lower output voltage, is intended to top up a starter battery. 



Recently Viewed Items

TOP